About the installation and maintenance of the magnetic voltage regulator
Yixing Xingyi Special Transformer Co., Ltd. was founded in 1992. The company covers an area of 68,000 square meters, including 45,000 square meters of standard workshops. There are 360 employees, including 2 professor-level special transformer experts and 18 professional transformer designers. There are 15 manufacturing process control personnel, 22 quality control personnel, and 260 front-line production personnel. The main products are various electric furnace transformers with a single capacity of 110KV and below, and a single capacity of 50000KVA, rectifier transformers, magnetic voltage regulators, special transformers, power transformers, wind power transformers Power generation, photovoltaic power substations, reactors, etc.
Installation and maintenance:
1. The power supply voltage should conform to the input voltage on the nameplate of the magnetic voltage regulator;
2, the product must be well grounded to ensure safety;
3. When using, always pay attention that the output current should not exceed the rated value, otherwise it will easily reduce the product life and even burn it;
4. When using, the handwheel should be rotated slowly and evenly to avoid damage to the brushes or sparks;
5. The use of the magnetic voltage regulator should be checked frequently. If the brush is found to be too worn or damaged, it should be replaced with a brush of the same specification in time, and the number 0 sandpaper should be used to turn the handwheel under the brush several times to make The bottom surface of the brush should be ground flat and the contact is good before it can be used;
6. The surface of the coil in contact with the brush should be kept clean frequently, otherwise it is easy to increase sparks and burn the surface of the coil. If you find black spots on the surface of the coil, you can wipe it off with cotton yarn dipped in alcohol until the surface spots are removed;
7. From the power supply to the equipment, the wires and wire terminals of the equipment to the load should be in good contact and can pass the rated current of the magnetic voltage regulator;
8. When moving the product, do not use the hand wheel, but use the handle or lift the entire product to move;
9. When the product needs to be installed horizontally on a large panel or vertically installed on other bases, it can be fixed with the device holes of the product base;
10. The magnetic voltage regulator is often maintained and cleaned. Water droplets, oil stains, etc. are not allowed to fall into the product. The product must be powered off regularly to remove the accumulated dust.
